When a server is connected to a file server over the device that has an Eth-Trunk configured, one is able to run the mode lacp-dynamic command on the device to configure its Eth-Trunk to work in dynamic mode. This mode can implement both load balancing and redundancy. port default vlan 2ĭevices that are directly connected through an Eth-Trunk can support LACP, by running the mode lacp-static command you can configure the Eth-Trunk to work in static LACP mode. ![]() Consequently, broadcast packets are confined to within a single VLAN. Hosts within a VLAN can communicate with each other but cannot communicate directly with hosts in other VLANs. Virtual Local Area Network (VLAN) technology divides a physical LAN into multiple broadcast domains, each of which is called a VLAN. To configure ethernet port as a trunk port and allow to pass all vlans: It allows tagged frames from multiple VLANs and untagged frames from only one VLAN called native vlan. port default vlan 10Ī trunk interface often connects to a switch, router, AP, or voice terminal that can receive and send tagged and untagged frames simultaneously. Anything arriving on an access port is simply assumed to belong to the VLAN assigned to the port. Traffic is both received and sent in native formats with no VLAN tagging whatsoever. An access port belongs to and carries the traffic of only one VLAN within 2-layer switch.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |