Squeegee the top then bottom of each pane.Open the louvres up fully and use the washer (on the t-bar) to wash both sides of a few panes.There are certainly a variety of techniques that all work on louvres, but the professional is looking for good results with speed. If French/Colonial windows aren't hated enough by window cleaners, louvres almost make them look easy. (Using rags sometimes runs the risk of leaving lint and smudges.) The frames will normally need to be wiped over with a towel, which both cleans them and prevents water running onto the next windows below. The goal is to remove as much water as possible from the glass with the squeegee, without needing to go over touching up with a rag too much. Make sure to push the rubber right into the frame on the finishing edge. Place it so there is a good overlap of already cleaned window (20 - 100mm). Wipe the rubber with the towel each time before placing it on the glass again. Also, wipe the rubber of the squeegee, then go ahead and swipe across the window. This wipe should be on the glass, about a finger's width. To minimise drag marks from the squeegee starting point, use a towel (it doesn't matter if it's a bit damp) to wipe the edge you intend to start from. If the window is not big enough to warrant the snake technique, you need to go straight across or down (it doesn't really matter which) several times. Each time you do this, there is a little trail of soapy water left from where you started. The advantage of this is that you minimise the amount of times you need to place the rubber of the squeegee back onto the glass. If the window is big enough, use the regular 'snake pattern' technique. Make sure to give them a good scrub and get into the corners. The first thing to do is to wash the set of windows with soapy water.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |